Locating Pin/Stop - 2" Height (4 pack) (5/8" System) pliers Outside thread on the stud

Outside thread on the stud is 3/4-16

ENHANCED SPEED: Delivers up to 10% increased cut rate compared to 3M™ Cubitron™ II Performance Abrasives to help reduce the amount of time and pressure required to get the job done

PFERD 40021 COMBICLICK Fiber Disc 4-1/2" Dia

Fine grinding in multiple steps

ENHANCED SPEED: Delivers up to 15% increased cut rate compared to 3M™ Cubitron™ II Performance Abrasives to help reduce the amount of time and pressure required to get the job done

Locating Pin/Stop - 2" Height (4 pack) (5/8" System) pliers Outside thread on the studLocating Pin Stop, 2" Height These stops are turned and finished off with a black oxide and oil bath, they are slightly undersized at the bottom to slip fit into 5 8" (0. 625") table holes. Use a pair of pins to quickly set up (locate) an edge on your fixture tables. Use 4 pins together to quickly create a 90 or 45 degree angle. These work great with the BuildPro Inserta Clamps available through our site here as the fastest, simplest way to setup